2015 Honda Civic
Mileage
128,225
Service Date
10/29/2025
Services Performed
- VALVE CLEARANCE – ADJUST – [Adjust only if noisy.] AUTOMATIC TRANSAXLE FLUID – INSPECT BRAKE FLUID LEVEL – INSPECT BRAKE HOSES & LINES – INSPECT – [Check the master cylinder and ABS/VSA modulator-control unit for damage and leakage.] CLUTCH FLUID – INSPECT DRIVESHAFT/PROPELLER SHAFT DUST BOOTS – INSPECT – [Check boots for cracks and boot bands for tightness.] ENGINE COOLANT – INSPECT – [Check the coolant level in the coolant reservoir. Make sure it is between the MAX mark and the MIN mark. If the coolant level in the coolant reservoir is at or below the MIN mark, add coolant to bring it up to the MAX mark, then inspect the cooling system for leaks.] EXHAUST SYSTEM – INSPECT – [Check catalytic converter heat shields, exhaust pipes, and muffler for damage, leaks, and tightness. NOTE: According to state and federal regulations, failure to do this maintenance item will not void the customer's emissions warranties. However, Honda recommends that all maintenance services be done at the recommended interval, to ensure long-term reliability.] FRONT & REAR BRAKES – INSPECT – [Check pads and discs for wear (thickness), damage, and cracks. Check calipers for damage, leaks, and tightness of mounting bolts. Check the wheel cylinders for leaks. Check the brake linings for cracking, glazing, wear, or contamination.] FUEL LINES & CONNECTIONS – INSPECT – [Check for loose connections, cracks, and deterioration; retighten loose connections and replace damaged parts. NOTE: According to state and federal regulations, failure to do this maintenance item will not void the customer's emissions warranties. However, Honda recommends that all maintenance services be done at the recommended interval, to ensure long-term reliability.] MANUAL TRANSAXLE FLUID – INSPECT – [Raise the vehicle on a lift. Remove the filler plug and the sealing washer, check the condition of the MTF, and make sure it is at the proper level.] PARKING BRAKE – INSPECT POWER STEERING FLUID – INSPECT STEERING COMPONENTS – INSPECT – [Inspect tie-rod ends, steering gearbox, and gearbox boots. Check steering linkage. Check boots for damage and leaking grease. Check fluid lines for damage and leaks.] SUSPENSION COMPONENTS – INSPECT – [Check bolts for tightness. Check condition of ball joint boots for deterioration and damage.] WINDOW WASHER FLUID LEVEL – INSPECT ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE MAINTENANCE MINDER LIGHT – RESET – [Reset the Maintenance Minder Light after every service is performed. If the Light is reset without performing a service, the system will not show the proper maintenance intervals. This can lead to serious mechanical problems because you will no longer have an accurate record of when maintenance is needed.]
- Cross Tire Rotation
Andrew L. gave our service a 5 star review on 11/1/2025
